Have these ready before you start.
Your trackerSalind 11 4G 2.0 or 2.0 Xtreme. Both have the same back, so the same plate fits either.
The magnetic plateThe plate with its two magnets and four silicone feet.
2 screws and a screwdriverUse a screwdriver that fits the screws. They hold the plate on the back of the tracker.
The plate goes on the back of the tracker. It takes four steps.
- Get the back facing up. Lay the tracker down so its back is facing up. Hold the plate next to it with the magnets facing up.
- Lower the plate on. Lower the plate straight onto the back of the tracker. The pegs on its underside drop into the notches on the back.
- Fasten the two screws. Put the two screws into the two screw holes in the plate and tighten them with the screwdriver.
- Check and place it. Check that the plate sits flat and does not wobble. Then put the tracker on a magnetic metal surface.
The video has no sound. The four steps say the same thing, so you can follow either one.
Visit our Support Page — available 24/7.