Open the package and confirm you have everything below before you start.

Salind 08 4G GPS trackerThe device itself, with the OBD-II plug built into the housing and the SIM already installed inside.

90° angle adapter (when included)Use this if your OBD-II port is in a tight spot where a straight tracker would foul the pedals or cover panels.

Pre-installed M2M SIM cardLives inside the tracker. Non-replaceable — you won't see it.

Have your device ID ready. Activate the device using the device ID printed on the back of the tracker. Have it ready before you start.

Four things to know before you plug it in. The OBD-II plug is built into the case — nothing to assemble.

OBD-II plugThe 16-pin connector on the end of the case. Plugs straight into your vehicle's OBD-II port.
LED signals (2)Orange (network), blue (GPS). Visible on the top surface.
Sealed enclosureNo flap, no switch. Power is supplied by the vehicle through the OBD-II port.
Device ID label

Weight	45 g (~1.6 oz)
Dimensions	52.4 × 46.4 × 22.7 mm (2.1 × 1.8 × 0.9 inch)
Power input	9–35 V DC via OBD-II port (12 V / 24 V vehicles)
Backup battery	None — tracker stops reporting when unplugged
Active tracking	Continuous — no standby mode
Cold start	3–5 min
In-operation start	1–10 sec
GPS chip	AT6558R
GPS accuracy	Up to 5 metres
GPS reception sensitivity	−162 dBm
Operating temperature	−20 °C to +75 °C (−4 °F to +167 °F)
Storage temperature	−30 °C to +80 °C (−22 °F to +176 °F)
Humidity	10 % to 85 %
Water protection	Cabin-rated only — keep dry, OBD-II install is inside the passenger compartment
OBD-II compatibility	All cars and light trucks built since 1996 (legal requirement for emissions diagnostics)
SIM	Pre-installed M2M, non-replaceable
Coverage	100+ countries

Set up your Salind 08 4G.

Tracker. Optional angle adapter.